1 Topic by MALLEN

  • MALLEN
  • Newbie
  • Offline
  • Registered: 2018-06-07
  • Posts: 2

Topic: Broken, worn out, useless nozzles for mini

I'm looking for a few ruined nozzles for the Da Vinci Mini. (in fact, of the part in the picture, the brass end is the only part that I REALLY need) One that's worn out (like from printing abrasive fiber) or has something jammed in (drill bit, end of a pick,or whatnot) or whatever is not only fine, but preferred. I am planning on modifying mine so that I can install a replaceable nozzle, but I want something to try on before I do the good one. The first tries don't even have to be something I can actually make work in the end, just something I can test techniques on, so I want dead ones rather than paying for good ones (and ruining a perfectly good part someone could use to fix their printer, as I hate wasting perfectly good stuff).





Mini.http://soliforum.com/i/?1ahRlpY.jpg

2 Reply by yizhou.he

  • yizhou.he
  • yizhou.he
  • Member
  • Offline
  • From: Boston, MA
  • Registered: 2017-07-05
  • Posts: 1,358

Re: Broken, worn out, useless nozzles for mini

All you need is to replace the copper heat block-nozzle fusion with E3D clone heat block and nozzle. May need to adjust z-offset a little. You can keep stock heating element and themisistor.

(Da Vinci 1.0, Jr. 1.0 RAMPS, miniMaker) X4, (Creality CR-10S, CR-10 mini, Ender-3) X4, Anycubic MEGA X4, Anycubic Chrion X1, ADMILAB Gantry X2 (MonoPrice Maker Select V2, Plus, Ultimate)X4--Select mini X1, Anycubic photon X4, Wanhao duplicate D7 X1.
iNSTONE Inventor Pro X2, CTC Dual X2, ANET-A8, Hictop 3DP-11, Solidoodle Press, FLSUN I3 2017X1

3 Reply by david.tucker

  • david.tucker
  • Member
  • Offline
  • Registered: 2017-10-07
  • Posts: 237

Re: Broken, worn out, useless nozzles for mini

I have a ruined heater nozle from a mini you can have. Email me your address to David.tucker at goliathindustries.com