1 Topic by mark.giblin

  • mark.giblin
  • mark.giblin
  • Member
  • Offline
  • From: Nottingham
  • Registered: 2018-03-26
  • Posts: 152

Topic: Anyone know where I can get...

Some STL files for the following...

A mounting bracket(s) for a NEMA17 motor to fit a clone i3 by GeeeTech. This is on the Y azis.

A simple GT Timing belt mount for the Y axis -- mod I have done is perfectly fine, wanted to incorporate the block and the bracket I purchased to fit properly. The supplied block I was able to tun by 90 degrees, redrill holes so that the tension on the belt, motor mounts wasn't as great as it was when I first tried it and heard part of the mounting bracket snap.

It is solid fro the moment but as my first print, I think that I need to get this bracket replaced.

I tried looking on thingyverse and despite joining, wondered where I download from as all the designs I looked at for things were all showing the design but no download link? What gives? Thought it was a free site?

Suggestions please.

Much appreciated.

Bob's your uncle (and likely your father too...)
I laughed that hard, I burst my colostomy bag.... (When I got my GeeeTech Pi3 ProB)
Prusa i3 MK2 clone by GeeeTech aka Pi3 ProB with a GT2560 board on MX17 Linux.

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Anyone know where I can get...

I think you missed a step click on the photo of the item you like it will take you to the thing page download link upper right hand corner.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by mark.giblin

  • mark.giblin
  • mark.giblin
  • Member
  • Offline
  • From: Nottingham
  • Registered: 2018-03-26
  • Posts: 152

Re: Anyone know where I can get...

Ok, thanks.

Managed to find one that will more than do the job.

Bob's your uncle (and likely your father too...)
I laughed that hard, I burst my colostomy bag.... (When I got my GeeeTech Pi3 ProB)
Prusa i3 MK2 clone by GeeeTech aka Pi3 ProB with a GT2560 board on MX17 Linux.

4 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Anyone know where I can get...

glad to be of help

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura