1 Topic by Blong001 (edited by Blong001 2017-10-29 17:19:47)

  • Blong001
  • Newbie
  • Offline
  • Registered: 2017-10-29
  • Posts: 3

Topic: Problem with pneumatic fitting coupler

When I feed the filament through and start printing the teflon tube pops out. I know its because the teeth inside are messed up, but now when I try to but it back in, it wont screw in. The problem is not occuring at the extruder, its not screwing in where you load the filament at. I had to use tweezers to undo it, and now it just doesnt want to go back in. HELP!

Post's attachments

20171029_131409[1].jpg
20171029_131409[1].jpg 1.63 mb, 1 downloads since 2017-10-29 

You don't have the permssions to download the attachments of this post.

2 Reply by yizhou.he

  • yizhou.he
  • yizhou.he
  • Member
  • Offline
  • From: Boston, MA
  • Registered: 2017-07-05
  • Posts: 1,358

Re: Problem with pneumatic fitting coupler

Boy, so many people have this problem. Check my previous answer and see if this helps.

http://www.soliforum.com/topic/16857/he … gfeed-end/

(Da Vinci 1.0, Jr. 1.0 RAMPS, miniMaker) X4, (Creality CR-10S, CR-10 mini, Ender-3) X4, Anycubic MEGA X4, Anycubic Chrion X1, ADMILAB Gantry X2 (MonoPrice Maker Select V2, Plus, Ultimate)X4--Select mini X1, Anycubic photon X4, Wanhao duplicate D7 X1.
iNSTONE Inventor Pro X2, CTC Dual X2, ANET-A8, Hictop 3DP-11, Solidoodle Press, FLSUN I3 2017X1