1 Topic by sfraden

  • sfraden
  • Member
  • Offline
  • Registered: 2015-01-25
  • Posts: 33

Topic: Da Vinci Jr 1.0A Up for sale....

Yes, that's right a Jr 1.0 A, quite possibly might be one of a kind.  This unit is similar to the other Jr models in size and function, but has quite a few differences (updates).  for start, the bed print area is larger and the bed itself is removeable.  It also has better cooling tunnel on the hot end, auto leveling bed, auto calibration and takes SD cards.  This does NOT use any filament, currently takes the Jr Spools from XYZ.

Asking $400 w/ free shipping....contact me at [email protected] if you are interested...
\
http://soliforum.com/i/?Q8wxxyu.jpg
http://soliforum.com/i/?0PTt5QW.jpg
http://soliforum.com/i/?HVu80wi.jpg
http://soliforum.com/i/?QXBjl1z.jpg

2 Reply by mickger

  • mickger
  • Newbie
  • Offline
  • Registered: 2017-08-07
  • Posts: 2

Re: Da Vinci Jr 1.0A Up for sale....

Where did you get this piece ? http://soliforum.com/i/?FVZaCWk.png

3 Reply by sfraden

  • sfraden
  • Member
  • Offline
  • Registered: 2015-01-25
  • Posts: 33

Re: Da Vinci Jr 1.0A Up for sale....

Ah, that piece is a special fan shroud that funnels the air back toward to head to provide cooling for the PLA.  Its part of the print head assembly now on the Jr PRO and the Jr 1.0a models....

4 Reply by JoeHanson (edited by JoeHanson 2017-09-25 22:58:15)

  • JoeHanson
  • Newbie
  • Offline
  • Registered: 2016-01-11
  • Posts: 2

Re: Da Vinci Jr 1.0A Up for sale....

You can print one and install it yourself -

https://xyzprod.blob.core.windows.net/d … 100_US.pdf

http://us.gallery.xyzprinting.com/us_en … 2171056219

5 Reply by mjf55

  • mjf55
  • Member
  • Offline
  • From: Raleigh, NC
  • Registered: 2017-06-01
  • Posts: 336

Re: Da Vinci Jr 1.0A Up for sale....

JoeHanson wrote:

You can print one and install it yourself -

https://xyzprod.blob.core.windows.net/d … 100_US.pdf

http://us.gallery.xyzprinting.com/us_en … 2171056219

Thanks for the official link.  i stumbled on this on stlfinder, not knowing it was from xyzprinting.  I did print it, but found that it would hit the bed glass holder when near the front edge of the bed.  It looks a little different in the width of the duct on the bottom.

Oh well. 
Some day i'll install my E3D clone