Topic: Fluttershy!
Yay!
Another pony.
Didn't get a chance to do any finishing. Basically just took it off the printer, cut off a few strings of stray plastic, and glued together with abs cement.
Re: Fluttershy!
Nice!
Care to share the stl?
...sativas are for smoking!
- Brad
- Administrator
- Offline
Re: Fluttershy!
Right here: http://www.thingiverse.com/thing:27225
There are 2 STLs for this one, the top half and the bottom half.
Re: Fluttershy!
Thanks! I've been toying with the idea of chopping up models such as this, and printing the part to make one huge model.
...sativas are for smoking!
- Brad
- Administrator
- Offline
Re: Fluttershy!
I think netfabb works well for chopping up models so you don't need support, but sometimes I find the pieces of the model don't fit perfectly together, one surface being a little too large. Maybe I just need to recalibrate my printer.
Re: Fluttershy!
Brad wrote:
I think netfabb works well for chopping up models so you don't need support, but sometimes I find the pieces of the model don't fit perfectly together, one surface being a little too large. Maybe I just need to recalibrate my printer.
That's what I was afraid of. I used Netfabb basic to chop up the Maltese Falcon into 6 pieces, but I've yet to print it. I should be printing it on Sunday.
...sativas are for smoking!
Re: Fluttershy!
Don't forget about the first layer squish causing a lip. Also if you have Y axis backlash that can affect how they fit together as well.
- Brad
- Administrator
- Offline
Re: Fluttershy!
Yes I think it is the first layer squish. I think I am squishing my first layer too much.
Re: Fluttershy!
How many hours did you have finishing that last one? Looks like an awful lot of hairs and banding to sand down.