1 Topic by duusangladovic

  • duusangladovic
  • Newbie
  • Offline
  • Registered: 2016-12-09
  • Posts: 1

Topic: Da Vinci AIO extruder problem

Hello guys! I have an extruder problem with Da Vinci AiO 3d printer. After few layers of printing (on about 1mm) extruder starts to make noise and nothing is coming out from the nozzle. I am using Color Fabb PLA filament and Sli3er for generating G-CODE. I cleaned the nozzle, tried to change lots of stuff like temperature, retraction, printing speed i also added fans, but nothing. Every time the same problem.

Here is the link for the pictures and video of the noisy extruder. https://drive.google.com/drive/folders/ … sp=sharing

I appreciate all kind of help and answers! Thank you guys.

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Da Vinci AIO extruder problem

you might have better luck getting responses by posting this in the XYZ section of the forums.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1