1 Topic by paulowaisberg

  • paulowaisberg
  • Newbie
  • Offline
  • Registered: 2016-09-28
  • Posts: 9

Topic: Assembly question

I just finished the mechanical assembly.

It looks like the pipe hole is not completely in the vertical position, but it came as a really thigh fit to the flange. I am worried to break it if I try to make it aligned. Anyone with a similar problem?

http://soliforum.com/i/?vqt9XQU.jpg

2 Reply by Kronikabuse

  • Kronikabuse
  • Kronikabuse
  • Member
  • Offline
  • From: Wi
  • Registered: 2014-08-03
  • Posts: 709

Re: Assembly question

doesnt have to be perfect. mines at an angle and works just fine

Sd4 #9080 with a glass bed. E3d chimera duel extruder. Paste extruder , duet wifi.
Lawsy carriages. linear bearings. Y axis direct drive, Kinect scanner
SD4#8188 glass bed, lawsly carriages, E3d v6, octoprint http://www.ustream.tv/channel/hotrod96z28
Filastruder/filawinder, Custom Delta 300mm x 600mm

3 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: Assembly question

Replied to your email also, but that is OK. Anything within 45 degrees of vertical should feed fine.

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend