Best/Easiest E3DV6 mod for 1.0

Probably the easiest  way to mount an ed3 is  mounting it to a titan extruder.
There has been a fair bit of discussion about this.

Yeah, that's pretty much how I did it.
Although I didn't bother taking the carriage off, just made the cuts with it in place.

They largely say it's the easiest because of this:

http://www.thingiverse.com/thing:1634298

You'll still need to print that.  It replaces your carriage entirely (you'll need the bushings and the circuit board).  The Titan also lets you print TPU filaments / NinjaFlex.

Otherwise everyone seems to use this (OSM's video):
http://www.thingiverse.com/thing:707530

There are some other carriage replacements:
http://www.thingiverse.com/thing:1312890
http://www.thingiverse.com/thing:844221
http://www.thingiverse.com/thing:709228
http://www.thingiverse.com/thing:734876

So I printed this carriage http://www.thingiverse.com/thing:1634298 but some how i thought  I should remove the clip for the belt holder since that part didnt print exactly right on one side.. OPPS. anyway to fix that without printing a new carriage? I spend a lot of time removing the supports cause i wasn't sure if it would print right without them. then i cleaned up the part with sandpaper, a rasp and did an vapor bath and it looks nice. first print btw that finished. I really don't want to print for another 7 hours... jsut to go to the hassle again. any ideas?