You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Filastruder → Motor Controller Display Failure
What gives? Thing has only been run 3-5 days on the weekend.
The red LEDs are dim and the display is dim, and doesn't change.
Anybody seen this before?
The unit does appear to be working... But i don't see the current limit light coming on,even when putting some extra back pressure on with a pair of pliers.
After cycling power, now the red lights and display don't come on at all.
Blue light still does, and the motor does turn.
Just to see if anyone has a comment.
My power into the board is from some old 12V 3 amp laptop charger.
Haven't hooked a scope up to it, but the multimeter says 12VDC.
I had turned the voltage up to 13-15 ish depending on the day.
Should i use a 15VDC or greater supply?
Voltages higher than 12v will increase brush wear on the motor.
SoliForum - 3D Printing Community → Filastruder → Motor Controller Display Failure
Powered by PunBB, supported by Informer Technologies, Inc.
