E3D Titan extruder (Page 9 of 16)

What temp are you printing the ABS at ?
I'm just wondering if it's not quite hot enough ???

Did you just now install the v6 or was it already working and you just added the titan?

If you changed the thermistor, did you update the table in the FW to use the new values?

I find I need to print ABS at 240°c with the E3D to get good bonding.
I get problems with delamination otherwise.

I will be making the changes shortly, I can't wait!!

I am onto another print, this nozzle is really low now. It hits the metal cleaner clip, it really cleans it :-)

I was unable to get good prints with .015 feeler when bed leveling, I had to revert back to paper. With the .015, I was not getting good adhesion on the first layer and it was making a mess. I switched back to a single piece of paper and now things are looking good again.

The pancake stepper motor forced me to use the medium sized screws that came with the Titan, however, the bottom left was barely catching on the threads so I put a longer screw with a spacer so I could tighten it down. I am not sure if the depth of the screw holes is shorter on the pancake compared to a larger stepper motor. I am going to look at the specs and find out.

All in all, this is working nicely. I have yet to try TPU or Ninja, that will be my next test.

I've had that. It's the Y axis out of line.  Push it to the back then give the right hand a bit of a push to reline it.

My cheap mod is printing flexi great. Not as nice looking as the E3D one.

Normal Simplify3D settings. Haven't changed a thing.
But I couldn't believe how much weight I've saved.

As you can see my Y axis was out.

Nope. It was a pain setting Repetier. I had to flash as a 1.0 with the new board.
Oh that's a clone E3D and I've lowered the small board on the right now.

No. I got the motor\clone\fan\extruder from bang good.

http://www.banggood.com/JKM-42-Hybrid-S … 33548.html

I had to swop the middle wires for it to work. My thread got moved to the top of this forum. Post there
if you need the links to the parts.

So this is the exact stepper that you used Viper?

Also what would be a link to a "Drop-in" replacement for the standard DaVinci stepper.  I plead ignorance when it comes to steppers.  Looks like it needs to be 1 amp and step angle of 1.8, correct?

If someone has a link to the larger version that I could use it would be appreciated.  I don't mind doing some rewiring as long as I know what wires to connect to where. 

Thanks

Mark