1 Topic by rockyrude

  • rockyrude
  • Member
  • Offline
  • Registered: 2016-02-22
  • Posts: 11

Topic: Slic3r issue with xyz ware

I have the DaVinci 2.0 duo and have converted a Slic3r file to xyz ware with the established header and footer mods through notepad++ . When I send the file to the printer I get a device not found error.

2 Reply by Telemachus

  • Telemachus
  • Member
  • Offline
  • From: Riverside, CA
  • Registered: 2016-01-19
  • Posts: 289

Re: Slic3r issue with xyz ware

I did that for about a week, but it was so cumbersome. 

Repetier firmware makes it so much more convenient!

Da Vinci 1.0a.  Repetier 0.92.  E3D V6.  Titan Extruder.  Sllic3r.  Octoprint on Raspberry Pi B+.

3 Reply by TheNeck (edited by TheNeck 2016-02-23 00:12:33)

  • TheNeck
  • TheNeck
  • Member
  • Offline
  • Registered: 2014-05-25
  • Posts: 77

Re: Slic3r issue with xyz ware

i know you have the 2.0, but try this link. it has works great for me with the 1.0.

https://www.enoworx.gr/blog/122-using-s … 3d-printer