1 Topic by gerardobahena

  • gerardobahena
  • Newbie
  • Offline
  • Registered: 2016-02-06
  • Posts: 3

Topic: 1.0 extruder wont heat up after replacement. Repetier

I just replaced my extruder after the original finally gave out totally on me. I connected everything right (ive gone through the directions a bunch of times) The problem is that it wont heat up on repetier. I can set it through the printer but it wont heat up. it stays at 20. and turning it up on the computer wont do anything either, it says heating extruder but nothing happens

2 Reply by mark.burton

  • mark.burton
  • Member
  • Offline
  • From: United states
  • Registered: 2015-05-28
  • Posts: 336

Re: 1.0 extruder wont heat up after replacement. Repetier

You may want to check that you didn't short out the connection and blow the 0 ohm resisters.

I keep seeing this come up wonder if we should make this thread http://www.soliforum.com/topic/12398/fu … -extruder/ sticky