1 Topic by immunity20

  • immunity20
  • Newbie
  • Offline
  • Registered: 2016-02-11
  • Posts: 7

Topic: Cleaning nozzles before printing , Da vinci 2.0 repetier 0.92

Hello is there any command (just as xyzware) to clean nozzles at the cans before starting the printing?

Also i slide my object on simplify3d and i think noozle extrude filament before arriving the starting point

2 Reply by robertf

  • robertf
  • Member
  • Offline
  • Registered: 2015-04-08
  • Posts: 78

Re: Cleaning nozzles before printing , Da vinci 2.0 repetier 0.92

If you are using sd cards I think you could save a g code to do the nozzle wipe and execute it in your header with one of the m codes.  otherwise youll have to put all the motion commands in the header

3 Reply by immunity20 (edited by immunity20 2016-02-16 17:36:37)

  • immunity20
  • Newbie
  • Offline
  • Registered: 2016-02-11
  • Posts: 7

Re: Cleaning nozzles before printing , Da vinci 2.0 repetier 0.92

does anyone or somewhere has the command for wipe both nozzles in Da vinci 2.0 ? big_smile

EDIT:
Hm i got sample code from sd card

in the begining there is the above code ###EDIT: its the code for printing 2lines in the corner before starting the printing###

T0
G92 E0
G1 F1800.000 E-1.00000
G92 E0
G1 Z0.350 F2700.000
G1 X3.000 Y179.988
G1 F1800.000 E1.00000
G1 X3.000 Y79.988 F270.000 E15.55131
G1 X5.000 Y79.988 E15.84234
G1 X5.000 Y179.988 E30.39364
G1 X3.150 Y179.988 E30.66284
G1 F1800.000 E24.66284
G92 E0
T1
G92 E0
G1 E-1.00000
G92 E0
G1 X146.988 Y179.988 F2700.000
G1 F1800.000 E1.00000
G1 X144.988 Y179.988 F270.000 E1.29103
G1 X144.988 Y79.988 E15.84234
G1 X146.988 Y79.988 E16.13336
G1 X146.988 Y179.838 E30.66284
G1 F1800.000 E24.66284
G92 E0
T0
G92 E0

4 Reply by luc

  • luc
  • Member
  • Offline
  • Registered: 2014-12-17
  • Posts: 138

Re: Cleaning nozzles before printing , Da vinci 2.0 repetier 0.92

M100 is the clean command