1 Topic by barry1685

  • barry1685
  • Member
  • Offline
  • Registered: 2014-11-23
  • Posts: 203

Topic: Ramps for davinci

Hey everyone. I have jumped ship from davinci and I am running a new printer. Please message me with any interest.

So I am selling:

Ramps 1.4 with mega (marlin firmware loaded compatible to work with davinci) 3 months old
ATX power supply that is ready to power ramps.
Smart LCD screen (hooks up to ramps to control settings)


Other items I am selling:

Davinci spare parts ( stepper motors, power supply, rails, carriages)

NEW borosilicate glass board (with heater) - replaces davinci's crappy heated glass plate

NEW hardened steel x axis rods (machined to replace davinci's x axis rods for linear bearings)

2 Reply by Skilbride

  • Skilbride
  • Newbie
  • Offline
  • Registered: 2015-12-29
  • Posts: 1

Re: Ramps for davinci

How much for the print bed?

3 Reply by rv.mike

  • rv.mike
  • Member
  • Offline
  • Registered: 2015-01-02
  • Posts: 59

Re: Ramps for davinci

Would you happen to have the original motherboard? Working?

4 Reply by techgeek

  • techgeek
  • Newbie
  • Offline
  • Registered: 2016-01-05
  • Posts: 3

Re: Ramps for davinci

Interested in the LED bar if you have that...?

5 Reply by kev0175 (edited by kev0175 2016-01-06 01:54:51)

  • kev0175
  • Member
  • Offline
  • Registered: 2015-02-17
  • Posts: 146

Re: Ramps for davinci

I'm interested in rhe NEW hardened steel x axis rods (machined to replace davinci's x axis rods for linear bearings) if you still have them.  PM me

Da Vinci  AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter,  Installed a Extruder Controller for higher temps

6 Reply by rv.mike

  • rv.mike
  • Member
  • Offline
  • Registered: 2015-01-02
  • Posts: 59

Re: Ramps for davinci

Have you got anything left?