1 Topic by scobo

  • scobo
  • scobo
  • Member
  • Offline
  • From: Scotland - UK
  • Registered: 2014-08-09
  • Posts: 993

Topic: Ok to remove extruder pcb ?

Does anyone know if it's ok to remove the small pcb used by the stock extruder ?
I'm now on repetier and E3D so I've no use for the filament sensor.
Can you connect the thermistor and fan directly to the main board and discard the small pcb ?

Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs

2 Reply by luc

  • luc
  • Member
  • Offline
  • Registered: 2014-12-17
  • Posts: 138

Re: Ok to remove extruder pcb ?

yes can be removed - this board is for filament sensor and Jam sensor

3 Reply by scobo

  • scobo
  • scobo
  • Member
  • Offline
  • From: Scotland - UK
  • Registered: 2014-08-09
  • Posts: 993

Re: Ok to remove extruder pcb ?

Thanks luc, that's the answer I was hoping for ! smile

Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs