1 Topic by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: delimonine for removing support

I printed a part with support (hips) and when i got out my Delimonine (which i have not used in a few month) the jug looked like this.
is it still safe to use. it looks like half the jug evaporated. and the jug collapsed.
http://soliforum.com/i/?dRYNuYF.jpg

Ultimaker S3.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: delimonine for removing support

It looks to me as though it was put away warm and cooled to suck the bottle in.  The only way to find out is try it and see.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by dubbsd (edited by dubbsd 2015-12-25 22:25:32)

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: delimonine for removing support

Thanks wardjr that is what I was thinking. I am more worried about the evaporation is the delimanine going to ruin my print.
I am printing a small part to test it I don't want to ruin a 15 hour print.

Ultimaker S3.