1 Topic by dedafmonteur

  • dedafmonteur
  • Member
  • Offline
  • Registered: 2015-12-15
  • Posts: 22

Topic: TUTORIAL: Da Vinci 1.0 extra filament cartridge room

So i was sick of all those cartridges laying around in my workshop. I solved this by making extra room in the printer.

1: Remove the back panel fro he Da Vinci (6 torx screws)
http://soliforum.com/i/?hbgHFwA.jpg

2: Mark the plastic that you want to remove
http://soliforum.com/i/?kgx5vJA.jpg

3: Remove the plastic with a saw (I used a Dremel)
http://soliforum.com/i/?XZrxttq.jpg

4: File off the molten plastic and  insert a few soft pads to make a snug fit
http://soliforum.com/i/?gkpoqpN.jpg

6: Put back the back panel and enjoy!
http://soliforum.com/i/?dYY2S7K.jpg

2 Reply by dedafmonteur

  • dedafmonteur
  • Member
  • Offline
  • Registered: 2015-12-15
  • Posts: 22

Re: TUTORIAL: Da Vinci 1.0 extra filament cartridge room

Can a mod mod move this topic, i put it in the wrong section.