1 Topic by dedafmonteur

  • dedafmonteur
  • Member
  • Offline
  • Registered: 2015-12-15
  • Posts: 22

Topic: Hey guys!

Hello 3d printing enthusiastics!

My name is Wouter, 24 years old and live in The Netherlands. I've been following 3d printing for years and finally bought a Da Vinci 1.0.  I like the way it prints and the ease of use.

I tared it apart after a few hours and installed an extra fan and better heatsinks.

2 Reply by grob

  • grob
  • grob
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2014-01-02
  • Posts: 900

Re: Hey guys!

Welcome to the forum, happy printing!

I have a feeling you're going to get along well around here:

dedafmonteur wrote:

I tared it apart after a few hours and installed an extra fan and better heatsinks.

SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi

3 Reply by dedafmonteur

  • dedafmonteur
  • Member
  • Offline
  • Registered: 2015-12-15
  • Posts: 22

Re: Hey guys!

grob wrote:

Welcome to the forum, happy printing!

I have a feeling you're going to get along well around here:

dedafmonteur wrote:

I tared it apart after a few hours and installed an extra fan and better heatsinks.

Well I was a mechanic in my early days (8 years ago) so i know a thing or two about electronics and that kind of jazz.