1 Topic by cnordwick

  • cnordwick
  • Newbie
  • Offline
  • Registered: 2015-11-19
  • Posts: 2

Topic: Printer Out Of Filament?

Hello all just finish flashed Repetier Firmware 0.92 and upgrade to E3Dv6 while I was at it everything is working great minus 1 thing Ill start a print and shortly after it says I'm out of filament.  So I have the filament running through the break out board so the optic could see it also tried running it out side and just keeping a piece of filament in there with no luck.  I have looked through the settings and cant find a thing on it and trolled the net for answers which lead me here.  Is there Gcode the I need to change do I still need to run a reset cartridge or is there a way to do away with optic?  Sorry for the dumb questions but new to this stuff and thank you in advance for at least reading my post.

2 Reply by scobo (edited by scobo 2015-11-19 16:45:35)

  • scobo
  • scobo
  • Member
  • Offline
  • From: Scotland - UK
  • Registered: 2014-08-09
  • Posts: 993

Re: Printer Out Of Filament?

On the LCD, go into 'advanced', 'settings' then set 'fil. sensors' to off.

Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs

3 Reply by cnordwick

  • cnordwick
  • Newbie
  • Offline
  • Registered: 2015-11-19
  • Posts: 2

Re: Printer Out Of Filament?

Thank you I had just found it been a long night but I have no excuse for not checking there.