1 Topic by tapoutms

  • tapoutms
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 54

Topic: Soliprint

someone know if soliprint work with solidoodle 2 because i can't make it work or do i need a special version can someone Help Please

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Soliprint

Use RH and Slic3r

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by tapoutms

  • tapoutms
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 54

Re: Soliprint

Thank you i use both but all my prints look bad I'm trying if something else is better for print

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Soliprint

You need to dial in your profiles or try cura.  Both are better than soliprint.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

5 Reply by tapoutms

  • tapoutms
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 54

Re: Soliprint

Thanks i will try that.

6 Reply by tapoutms

  • tapoutms
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 54

Re: Soliprint

Do you know the Cura settings for SD2

7 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Soliprint

I do not but there are several others that use Cura and hopefully they will chime in.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website