1 Topic by audreybest23

  • audreybest23
  • Newbie
  • Offline
  • Registered: 2015-10-18
  • Posts: 3

Topic: Issue with printing

Hello everyone, I'm new to 3d printing. Sometimes when I print stuff this kind of thing will happen(refer to image). I'm just not sure what's going on any advice? Any answers? Thank you so much for checking out my first forum post, I hope everyone out there is having a great day!

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Issue with printing

I'm no expert but it looks as though you forgot to attach the image.
Welcome to the forum I am certain we can help.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by audreybest23

  • audreybest23
  • Newbie
  • Offline
  • Registered: 2015-10-18
  • Posts: 3

Re: Issue with printing

http://soliforum.com/i/?i2tEt4Z.jpg

4 Reply by audreybest23

  • audreybest23
  • Newbie
  • Offline
  • Registered: 2015-10-18
  • Posts: 3

Re: Issue with printing

Sorry bout that I was submitting the image incorrectly

5 Reply by gcook

  • gcook
  • Newbie
  • Offline
  • Registered: 2015-10-16
  • Posts: 2

Re: Issue with printing

First thoughts ... your print gap isn't correct .. the first layer isn't being squished enough to fill the gaps and adhere to the print bed properly ... might want to check that the bed is level while your there also and could also be temp ? .. filament not melting enough ?...what are you using and at what temp ?