1 Topic by christophe

  • christophe
  • Newbie
  • Offline
  • Registered: 2015-09-16
  • Posts: 3

Topic: Hi everyone

I just found this forum and I have read some topics which are realy interesting. I have bought a DaVinci 1.0 about 6 months ago and it has given me some real headaches. But now, after having conquered some of the problems I realy love this machine, although it doesn't give me the right quality of the prints.
I bought the DaVinci to learn about 3D printing and I must say that I realy have used and abused it to see what it could do.
In the process I have broken about 4 glass plates and one time I blocked the extruder so I couldn't load the filament anymore.
But thanks to the company where I bought it, everything was repaired for free.

In the next days I'm going to make myself more farmiliar with this forum and try to share the things I have learned so far.
As you can see, my name is Christophe; I"m 49 and live in Belgium. Sorry for my bad English but I think that Flemish would realy be a hard nut to crack for most of you :-)

2 Reply by switchblade5984

  • switchblade5984
  • Member
  • Offline
  • Registered: 2015-09-05
  • Posts: 85

Re: Hi everyone

Welcome, I have no problem reading what you posted, good to have you on.

3 Reply by switchblade5984

  • switchblade5984
  • Member
  • Offline
  • Registered: 2015-09-05
  • Posts: 85

Re: Hi everyone

Welcome, I have no problem reading what you posted, good to have you on.

4 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Hi everyone

Hello Christophe, and welcome to soliforums. There is a section here dedicated to the Da Vinci printers, but you probably already found that.

Your English is fine, don't worry about it. In all honesty, I have found that the majority of non-native speakers actually do a better job than some native speakers do! wink

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1