1 Topic by raptor700yfz (edited by raptor700yfz 2015-08-24 22:58:44)

  • raptor700yfz
  • Member
  • Offline
  • Registered: 2015-08-19
  • Posts: 15

Topic: Looking for da Vinci 1.0 Extruder

I have a da Vinci All-in-one and I need a full Extruder assembley and I didn't want to buy a brand new one so please tell me what you got. Thanks

2 Reply by kev0175

  • kev0175
  • Member
  • Offline
  • Registered: 2015-02-17
  • Posts: 146

Re: Looking for da Vinci 1.0 Extruder

I'm not sure what all you need but I have a extruder assembly without the board and I tried to remove the thermistor and broke the wires off.

Da Vinci  AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter,  Installed a Extruder Controller for higher temps

3 Reply by mark.burton

  • mark.burton
  • Member
  • Offline
  • From: United states
  • Registered: 2015-05-28
  • Posts: 336

Re: Looking for da Vinci 1.0 Extruder

I have a DaVinci all in one that I swapped to the e3d. I'm still using the daughter board but don't need the rest of it. I cut off the ends for power connecter to the heater to use with my printer. The thermistor still has its connecter.