1 Topic by iadbd100

  • iadbd100
  • iadbd100
  • Newbie
  • Offline
  • Registered: 2015-08-24
  • Posts: 8

Topic: Printer bed temperature goes above 80°C and continues raising further

The print bed temperature of my newly bought DaVinci 1.0A keeps raising above 80°C instead of being fixed at 70°C and continues to rise. Whether I give a calibration commend or print command, it does the same and does not start printing or calibration. Temperature also raises very slowly and I believe the temperature is much higher then it shows in the display by touching. I use DaVinci 2.0 for the last 9 months. It never showed any problem. I bought 2 pieces of DaVinci 1.0 A and both are acting the same.

Firmware: latest
Cartridge: ABS (Newly purchased and old ones both showing the same result)

2 Reply by batmaster

  • batmaster
  • Member
  • Offline
  • Registered: 2015-06-04
  • Posts: 60

Re: Printer bed temperature goes above 80°C and continues raising further

on abs with stock firmware, my 1.0a would heat the bed to 90c.

3 Reply by iadbd100

  • iadbd100
  • iadbd100
  • Newbie
  • Offline
  • Registered: 2015-08-24
  • Posts: 8

Re: Printer bed temperature goes above 80°C and continues raising further

ow. But It starts to grow moisture droplets under the print bed? wont that be any problem?

4 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Printer bed temperature goes above 80°C and continues raising further

iadbd100 wrote:

ow. But It starts to grow moisture droplets under the print bed? wont that be any problem?


That moisture should dry out if you let it run, and should not hurt anything. The question would be how did moisture get in there in the first place? How are you cleaning the glass?

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

5 Reply by iadbd100

  • iadbd100
  • iadbd100
  • Newbie
  • Offline
  • Registered: 2015-08-24
  • Posts: 8

Re: Printer bed temperature goes above 80°C and continues raising further

This was my 1st run in this machine