XYZ Ware Open Mod Download

Many thanks Scobo.  You saved me.

Yes, that's what I used before I switched to repetier.

You're welcome.
I've got to say, although the open mod is an improvement over the stock software, I would HIGHLY recommend the switch to repetier for a much bigger improvement all round.

You can do it that way using an old version of xyzware and doing a firmware update with no internet connection but you'll only be able to flash the older version, repetier 0.91.
I just followed the guide to flash straight to 0.92 which is actually pretty simple as long as you follow it to the letter .... https://github.com/luc-github/Repetier-Firmware-0.92

Yeah but don't worry, apparently it's pretty much impossible to brick this printer.
All you're doing by shorting the jumper is completing a circuit which erases the eeprom.

I asked the same question before flashing.
This is the answer I got ... http://voltivo.com/forum/davinci-firmwa … r-91-vs-92

I think one of the reasons I went straight to 0.92 was simply because I couldn't find an old copy of xyzware so it was quicker to just go for it with the jumper shorting/Arduino route.

I believe that if your printer has firmware 1.1.E it will work.  Not sure if the 1.0a can use that firmware though.

I can just keep resetting the cartidge, my firmware is 1.0.6

what do i do with this .exe file? just replace it with the original?

Does the version of the xyzware matter?

I just finished my first print with repetier .91.  It is so much better then the stock firmware.  Thanks for getting me to do this!

Please share your slic3r settings. I don't see much improvement after flashing, even after hours and hours of calibrating...