1 Topic by bheimiller

  • bheimiller
  • Newbie
  • Offline
  • Registered: 2015-07-15
  • Posts: 7

Topic: Can you use Repetier firmware on any other model besides the 1.0?

...or the 1.0a?
I'm asking can you use Repetier or any other custom firmware on the Duo model(I think it's 2.0) and/or the All In One model(the one with the scanner)?

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Can you use Repetier firmware on any other model besides the 1.0?

Repetier works on all Da Vinci models except the JR. All you have to do is make the proper edits to the beginning of the configuration.h tab for your printer  in Arduino before you upload it with Arduino.

Note the scanner is not supported and will no longer function. It was a poor scanner anyways. You get better scans using a Kinect.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by bheimiller

  • bheimiller
  • Newbie
  • Offline
  • Registered: 2015-07-15
  • Posts: 7

Re: Can you use Repetier firmware on any other model besides the 1.0?

carl_m1968 wrote:

Repetier works on all Da Vinci models except the JR. All you have to do is make the proper edits to the beginning of the configuration.h tab for your printer  in Arduino before you upload it with Arduino.

Note the scanner is not supported and will no longer function. It was a poor scanner anyways. You get better scans using a Kinect.

Thanks, I figured that about the scanner.  Good news.