1 Topic by efes

  • efes
  • Member
  • Offline
  • From: Belgium
  • Registered: 2015-06-13
  • Posts: 110

Topic: WARNING: Firmware unresponsive

Hello
this is the first time I have this?


SENT: G1 X65.493 Y97.476 E20.1770
RECEIVED: ok 0
SENT: G1 X65.514 Y97.419 E20.1794
RECEIVED: ok 0
SENT: G1 X66.542 Y98.447 E20.2369
RECEIVED: ok 0
SENT: G1 X66.724 Y98.265 E20.2470
WARNING: Firmware unresponsive.  Attempting to force continue...
SENT: M105
SENT: G1 X66.909 Y98.135 E20.2560
WARNING: Firmware unresponsive.  Attempting to force continue...
SENT: M105
WARNING: Firmware unresponsive.  Attempting to force continue...
SENT: M105
WARNING: Firmware unresponsive.  Attempting to force continue...


it is stopped in the middle of work?

thx

davinci 1.0
firmware repetier

2 Reply by efes

  • efes
  • Member
  • Offline
  • From: Belgium
  • Registered: 2015-06-13
  • Posts: 110

Re: WARNING: Firmware unresponsive

I start working from the PC, now I run from the SD card, I hope not to have the problem!

davinci 1.0
firmware repetier

3 Reply by kev0175

  • kev0175
  • Member
  • Offline
  • Registered: 2015-02-17
  • Posts: 146

Re: WARNING: Firmware unresponsive

Is this your first time printing this part  if so did you try sending through netfabb

Da Vinci  AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter,  Installed a Extruder Controller for higher temps

4 Reply by efes

  • efes
  • Member
  • Offline
  • From: Belgium
  • Registered: 2015-06-13
  • Posts: 110

Re: WARNING: Firmware unresponsive

netfabb it's better than simplify3d?

davinci 1.0
firmware repetier

5 Reply by kev0175

  • kev0175
  • Member
  • Offline
  • Registered: 2015-02-17
  • Posts: 146

Re: WARNING: Firmware unresponsive

Netfabb repairs parts but this may not be the problem

Da Vinci  AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter,  Installed a Extruder Controller for higher temps

6 Reply by efes

  • efes
  • Member
  • Offline
  • From: Belgium
  • Registered: 2015-06-13
  • Posts: 110

Re: WARNING: Firmware unresponsive

ah ok thx ...

davinci 1.0
firmware repetier