1 Topic by ncmoore12

  • ncmoore12
  • Member
  • Offline
  • Registered: 2015-07-06
  • Posts: 17

Topic: 3D Printing with High Temp Materials (i.e. Ultem, PEEK, PC)

3D Printing Community,

I was just testing the water to see what others have done out there as far as printing these materials and others that require high temp. If you could reply with the following i'm sure it would help my self and many others who are looking into these areas.

Material Used:

3D Printer Used:

Print Temperature:

Picture or Link if possible:

Any Suggestions you may have or info:

Printing with ABS, conducting research on experimental HT materials
XYZ Da Vinci 1.0 W/Slic3r, looking into new 3D printers.
1 Year of 3D printing experience
Studying Mechanical and Aerospace Engineering