You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Filastruder → operating filastruder
Hi,
I just assembled my filastruder (v.1.6) and I'am trying to test it out. Is there somewhere good step-by-step instructions available how to set up the pid controller and actually use the Filastruder. The manufactures information about the PID was very limited and the operating instructions in the filastruder manual really don't say how to set up the PID to actually turn on the heater and the motor. Any help would be awesome.
The PID controller doesn't turn on the motor, the switch does.
The temperature is set with the up/down buttons.
The PID controller doesn't turn on the motor, the switch does.
The temperature is set with the up/down buttons.
OK, now I understand how the motor works. I might be mistaken, but if not, I will mention that in the instructions, there is a small inconsistency between the wiring diagram and step-by-step instructions how to connect wires. Nowhere does it mention in the text (at least I could not see) that there should be a wire from pin 10 to stall protectors In-. When I went through the wiring diagram I realised I had not made the connection and therefore were only switching on the fan not the motor.
Sorry about that, it must have gotten lost while editing the document. I've fixed it.
SoliForum - 3D Printing Community → Filastruder → operating filastruder
Powered by PunBB, supported by Informer Technologies, Inc.
