<![CDATA[SoliForum - 3D Printing Community — Cyclops hot end]]> https://www.soliforum.com/topic/9398/cyclops-hot-end/ Wed, 21 Jan 2015 03:36:27 +0000 PunBB <![CDATA[Re: Cyclops hot end]]> https://www.soliforum.com/post/80610/#p80610 You'll need a board that is capable of driving two extruders so something like a Rumba or any number of boards.  You will also need another motor and yes it is most likely to be a Bowden setup.  That's not to say it couldn't be setup as a direct drive as that is actually my plan.

]]> Wed, 21 Jan 2015 03:36:27 +0000 https://www.soliforum.com/post/80610/#p80610 <![CDATA[Re: Cyclops hot end]]> https://www.soliforum.com/post/80607/#p80607 Your questions have already been answered:

http://www.soliforum.com/topic/8507/e3d … zlehotend/

Lets keep discussion in a single thread.

]]> Wed, 21 Jan 2015 03:31:44 +0000 https://www.soliforum.com/post/80607/#p80607 <![CDATA[Cyclops hot end]]> https://www.soliforum.com/post/80606/#p80606 So what is required with this? Extra motor or Bowden set up? Rumba board or will the ole sang board from the sd3 work?

]]> Wed, 21 Jan 2015 03:26:44 +0000 https://www.soliforum.com/post/80606/#p80606