<![CDATA[SoliForum - 3D Printing Community — Taulman 618]]> https://www.soliforum.com/topic/865/taulman-618/ Mon, 06 May 2013 13:44:20 +0000 PunBB <![CDATA[Re: Taulman 618]]> https://www.soliforum.com/post/21882/#p21882 Theres a good extensive thread on both the Taulman 618 and a tiny bit on the new clear 645.

http://www.soliforum.com/topic/466/nylon/

]]> Mon, 06 May 2013 13:44:20 +0000 https://www.soliforum.com/post/21882/#p21882 <![CDATA[Re: Taulman 618]]> https://www.soliforum.com/post/21870/#p21870 Worked really great, oozed a bit more than I'd like it to.  The material was great though, but I didn't have a use for it on normal prints.  I printed at about 205, with a fan on constantly.  Printing at this temperature allowed the layers to adhere better to each other.

]]> Mon, 06 May 2013 06:02:36 +0000 https://www.soliforum.com/post/21870/#p21870 <![CDATA[Re: Taulman 618]]> https://www.soliforum.com/post/21865/#p21865 So what did you guys find out? I'm interested in trying this.

]]> Mon, 06 May 2013 02:30:02 +0000 https://www.soliforum.com/post/21865/#p21865 <![CDATA[Re: Taulman 618]]> https://www.soliforum.com/post/7742/#p7742 Yeah I ordered mine, I'm waiting on it to come though. 

From what I can tell like ronsii said, our extruder when heated to 195 is equal to a higher temperature, so I'll give it a go heated at around 200 when I get it, and go from there.

I'll make sure to document and show pictures to everyone here when it comes in though!

]]> Sat, 22 Dec 2012 07:23:36 +0000 https://www.soliforum.com/post/7742/#p7742 <![CDATA[Re: Taulman 618]]> https://www.soliforum.com/post/7741/#p7741 The extruder usually runs at least 30 degrees hotter then the setting you make in the control software.

I believe a few people on this forum are trying the taulman nylon.... aFoote I think is one of them????

]]> Sat, 22 Dec 2012 06:45:51 +0000 https://www.soliforum.com/post/7741/#p7741 <![CDATA[Taulman 618]]> https://www.soliforum.com/post/7740/#p7740 Anybody tried this stuff?

http://www.taulman3d.com/index.html

How can we turn the extruder up to the 240-250 needed?

]]> Sat, 22 Dec 2012 06:13:32 +0000 https://www.soliforum.com/post/7740/#p7740