<![CDATA[SoliForum - 3D Printing Community — Crooked build platform]]> https://www.soliforum.com/topic/484/crooked-build-platform/ Thu, 08 Nov 2012 22:12:29 +0000 PunBB <![CDATA[Re: Crooked build platform]]> https://www.soliforum.com/post/4260/#p4260 No need to rip any tape smile

I printed only about 1/4 of the thumbscrews (no need to have em so big) threaded on with a drop of CA and done deal.

]]> Thu, 08 Nov 2012 22:12:29 +0000 https://www.soliforum.com/post/4260/#p4260 <![CDATA[Re: Crooked build platform]]> https://www.soliforum.com/post/4255/#p4255 Yes there is. Using a pair of pliers you can turn the rod from underneath. Or you can print and have a look:
http://www.soliforum.com/topic/242/thum … m-beneath/

Aldo wrote:

Hello fellow doodlers,

today I wanted to print my first semi big object.
The Gap on the right side of the platform issn't even visible (good),
The Gap on the left   side is ... verry visible (pretty bad)...

Is there any possebility to adjust this, WITHOUT removing the Tape from the build platform?
This is some serious porblem, I know, the head could crash into the platform if it's done wrong...

Has anyone done this before?

Thanks for your advice in advance...

]]> Thu, 08 Nov 2012 21:35:03 +0000 https://www.soliforum.com/post/4255/#p4255 <![CDATA[Re: Crooked build platform]]> https://www.soliforum.com/post/4249/#p4249 Thank you verry much. ^^

]]> Thu, 08 Nov 2012 19:16:10 +0000 https://www.soliforum.com/post/4249/#p4249 <![CDATA[Re: Crooked build platform]]> https://www.soliforum.com/post/4244/#p4244 no .. you need to "poke" thru the kapton tape to put a hex wrench in the screw (don't remove the tape)

]]> Thu, 08 Nov 2012 18:13:22 +0000 https://www.soliforum.com/post/4244/#p4244 <![CDATA[Crooked build platform]]> https://www.soliforum.com/post/4241/#p4241 Hello fellow doodlers,

today I wanted to print my first semi big object.
The Gap on the right side of the platform issn't even visible (good),
The Gap on the left   side is ... verry visible (pretty bad)...

Is there any possebility to adjust this, WITHOUT removing the Tape from the build platform?
This is some serious porblem, I know, the head could crash into the platform if it's done wrong...

Has anyone done this before?

Thanks for your advice in advance...

]]> Thu, 08 Nov 2012 17:24:58 +0000 https://www.soliforum.com/post/4241/#p4241