I've only used the Repetier/Slic3r Solidoodle package. Would be interested in testing another slicer, but sounds like a pain setting one up.

http://www.soliforum.com/topic/348/kisslicer/

its really rather easy to use.  In my experience, the perimeters of parts made with KISSlicer look much better than with Slic3r.

I will try to post up an example tomorrow.

Those blobs are probably the starting points. Is "randomize starting points" selected in Slic3r?

That is exactly what the blobs are. I am just a little unsure on how to get rid of them other than to turn off randomize starting points. That only leaves a nice nasty line in my print. I know that increasing the retraction makes it worse so maybe if you aren't having oozing problems then decreasing retraction settings will make it better.

you might need to check your retraction settings. Trying turning the retraction length down(extruder settings) for this filament. Also, what temp did you extrude at? It looks like you had some issues with the layers not sticking together well. Maybe try to bump it up 5 degrees or so.

It looks like you are going the get an amazing print when you get this cleared up.

If I remember correctly this was printed at 200c with 100c bed, if not it was 195/95. I get these 'blobs' occasionally with other prints at .3mm, but it occurred much more frequently with this print. I've done a fair amount of printing since I got the printer a little over a month ago, haven't had any issues with layers sticking. This may be an anomaly since the vase walls are so thin and called for 0 infill. My main concern is figuring out what causes those blobs of ABS.

I've done a lot of the calibrations, but haven't looked into retraction settings. Will check it out, thanks!

It looks like you are going the get an amazing print when you get this cleared up.