SoliForum - 3D Printing Community — Bed leveling nightmares!

Re: Bed leveling nightmares!

null@example.com (Grendel) — Mon, 03 Dec 2018 08:44:12 +0000

now I may be wrong, but does the xyz not work in reverse when setting the correction? I am not certain, but I use the manual method for levelling and that works fine for me

Re: Bed leveling nightmares!

null@example.com (carl_m1968) — Mon, 03 Dec 2018 01:59:28 +0000

dasaint80 wrote:

Hey all, I have a davinci AiO 1.0 with repetier .92.10M it was running fine until my x axis started acting up, I fixed it (it needed to be greased up and tighen a bit).
Now I'm having a hell of a time getting a good quality print. Just leveling the bed it's become a nightmare. I'm at my witts end!
Auto leveling and z probing work fine but when I try to print the extruder cartridge bangs against the bed even after the z offset is set to -2.46mm.
I've tried using simplify3d, repetier host, or pronterface and it still has the same issue.
Thanks,
Steve

http://www.soliforum.com/topic/8408/bed … beginners/

Should be all you need.

Bed leveling nightmares!

null@example.com (dasaint80) — Mon, 03 Dec 2018 00:12:15 +0000

Hey all, I have a davinci AiO 1.0 with repetier .92.10M it was running fine until my x axis started acting up, I fixed it (it needed to be greased up and tighen a bit).

Now I'm having a hell of a time getting a good quality print. Just leveling the bed it's become a nightmare. I'm at my witts end!

Auto leveling and z probing work fine but when I try to print the extruder cartridge bangs against the bed even after the z offset is set to -2.46mm.

I've tried using simplify3d, repetier host, or pronterface and it still has the same issue.

Thanks,

Steve