<![CDATA[SoliForum - 3D Printing Community — stand alone slic3r]]> https://www.soliforum.com/topic/1477/stand-alone-slic3r/ Tue, 26 Feb 2013 22:59:25 +0000 PunBB <![CDATA[Re: stand alone slic3r]]> https://www.soliforum.com/post/14224/#p14224 I had a hard time finding this button myself.  One would think that it would be on the gcode tab next to the new and save buttons.  But the Load GCode button (on RH-Mac) is to the Right of the Connect/Disconnect button at the top left of the interface.

]]> Tue, 26 Feb 2013 22:59:25 +0000 https://www.soliforum.com/post/14224/#p14224 <![CDATA[Re: stand alone slic3r]]> https://www.soliforum.com/post/14210/#p14210 Export the g-code from kisslicer to a known location, then start repetier and load your g-code....from menu in RH.

]]> Tue, 26 Feb 2013 20:37:02 +0000 https://www.soliforum.com/post/14210/#p14210 <![CDATA[Re: stand alone slic3r]]> https://www.soliforum.com/post/14207/#p14207 thanks I'll try that but still need to know how to get the g-code from there to RH

]]> Tue, 26 Feb 2013 20:19:29 +0000 https://www.soliforum.com/post/14207/#p14207 <![CDATA[Re: stand alone slic3r]]> https://www.soliforum.com/post/14154/#p14154 I would try using a different slicer if you are still having problems.

my new favorite: http://www.soliforum.com/topic/348/kisslicer/

just make sure you set the offset as indicated in the thread so that the prints are centered.

]]> Tue, 26 Feb 2013 16:24:55 +0000 https://www.soliforum.com/post/14154/#p14154 <![CDATA[stand alone slic3r]]> https://www.soliforum.com/post/14103/#p14103 If use the standalone ver of  slic3r, how do I  the G-code it creates in RH , I know RH has slic3r in it  but there was a post about using it alone since I can't get objects to print in center of the bed even tho it shows centered in RH. Make sense?

]]> Tue, 26 Feb 2013 01:04:59 +0000 https://www.soliforum.com/post/14103/#p14103