<![CDATA[SoliForum - 3D Printing Community — Cyclops hot end]]> 2015-01-21T03:36:27Z PunBB https://www.soliforum.com/topic/9398/cyclops-hot-end/ <![CDATA[Re: Cyclops hot end]]> You'll need a board that is capable of driving two extruders so something like a Rumba or any number of boards.  You will also need another motor and yes it is most likely to be a Bowden setup.  That's not to say it couldn't be setup as a direct drive as that is actually my plan.

]]> https://www.soliforum.com/user/2291/ 2015-01-21T03:36:27Z https://www.soliforum.com/post/80610/#p80610 <![CDATA[Re: Cyclops hot end]]> Your questions have already been answered:

http://www.soliforum.com/topic/8507/e3d … zlehotend/

Lets keep discussion in a single thread.

]]> https://www.soliforum.com/user/221/ 2015-01-21T03:31:44Z https://www.soliforum.com/post/80607/#p80607 <![CDATA[Cyclops hot end]]> So what is required with this? Extra motor or Bowden set up? Rumba board or will the ole sang board from the sd3 work?

]]> https://www.soliforum.com/user/7171/ 2015-01-21T03:26:44Z https://www.soliforum.com/post/80606/#p80606