2014-08-20T03:41:11Z PunBB https://www.soliforum.com/topic/7393/how-do-you-do-a-manual-calibration/ no problem

]]> https://www.soliforum.com/user/6853/ 2014-08-20T03:41:11Z https://www.soliforum.com/post/63854/#p63854 thanks alot

]]> https://www.soliforum.com/user/6793/ 2014-08-20T02:57:25Z https://www.soliforum.com/post/63850/#p63850 Look here:
http://www.soliforum.com/topic/6496/tab … -the-sane/

]]> https://www.soliforum.com/user/6853/ 2014-08-20T02:51:12Z https://www.soliforum.com/post/63848/#p63848 xyz

]]> https://www.soliforum.com/user/6793/ 2014-08-20T02:45:40Z https://www.soliforum.com/post/63846/#p63846 Are you running xyzware? Or repetier firmware?

]]> https://www.soliforum.com/user/6031/ 2014-08-20T02:39:31Z https://www.soliforum.com/post/63845/#p63845 I know this subject has been covered but I didn't find a step by step, let me see if I've got it right. Start a demo print and shut off the print. Then manually move the extruder to the four corners above the glass in each corner(not above the metal tabs) use my 2mm feeler gauge to adjust the screws until the gauge barely makes contact with the extruder tip, not the tab thats used in the automatic leveling? Is this right? It's gotten to the point that it takes me an hour between every print to calibrate.

]]> https://www.soliforum.com/user/6793/ 2014-08-20T02:37:59Z https://www.soliforum.com/post/63844/#p63844