<![CDATA[SoliForum - 3D Printing Community — Crooked build platform]]> 2012-11-08T22:12:29Z PunBB https://www.soliforum.com/topic/484/crooked-build-platform/ <![CDATA[Re: Crooked build platform]]> No need to rip any tape smile

I printed only about 1/4 of the thumbscrews (no need to have em so big) threaded on with a drop of CA and done deal.

]]> https://www.soliforum.com/user/297/ 2012-11-08T22:12:29Z https://www.soliforum.com/post/4260/#p4260 <![CDATA[Re: Crooked build platform]]> Yes there is. Using a pair of pliers you can turn the rod from underneath. Or you can print and have a look:
http://www.soliforum.com/topic/242/thum … m-beneath/

Aldo wrote:

Hello fellow doodlers,

today I wanted to print my first semi big object.
The Gap on the right side of the platform issn't even visible (good),
The Gap on the left   side is ... verry visible (pretty bad)...

Is there any possebility to adjust this, WITHOUT removing the Tape from the build platform?
This is some serious porblem, I know, the head could crash into the platform if it's done wrong...

Has anyone done this before?

Thanks for your advice in advance...

]]> https://www.soliforum.com/user/12/ 2012-11-08T21:35:03Z https://www.soliforum.com/post/4255/#p4255 <![CDATA[Re: Crooked build platform]]> Thank you verry much. ^^

]]> https://www.soliforum.com/user/62/ 2012-11-08T19:16:10Z https://www.soliforum.com/post/4249/#p4249 <![CDATA[Re: Crooked build platform]]> no .. you need to "poke" thru the kapton tape to put a hex wrench in the screw (don't remove the tape)

]]> https://www.soliforum.com/user/40/ 2012-11-08T18:13:22Z https://www.soliforum.com/post/4244/#p4244 <![CDATA[Crooked build platform]]> Hello fellow doodlers,

today I wanted to print my first semi big object.
The Gap on the right side of the platform issn't even visible (good),
The Gap on the left   side is ... verry visible (pretty bad)...

Is there any possebility to adjust this, WITHOUT removing the Tape from the build platform?
This is some serious porblem, I know, the head could crash into the platform if it's done wrong...

Has anyone done this before?

Thanks for your advice in advance...

]]> https://www.soliforum.com/user/62/ 2012-11-08T17:24:58Z https://www.soliforum.com/post/4241/#p4241