<![CDATA[SoliForum - 3D Printing Community — Bed leveling nightmares!]]> 2018-12-03T08:44:12Z PunBB https://www.soliforum.com/topic/17761/bed-leveling-nightmares/ <![CDATA[Re: Bed leveling nightmares!]]> now I may be wrong, but does the xyz not work in reverse when setting the correction? I am not certain, but I use the manual method for levelling and that works fine for me

]]> https://www.soliforum.com/user/16373/ 2018-12-03T08:44:12Z https://www.soliforum.com/post/147740/#p147740 <![CDATA[Re: Bed leveling nightmares!]]> dasaint80 wrote:

Hey all,  I have a davinci AiO 1.0 with repetier .92.10M it was running fine until my x axis started acting up, I fixed it (it needed to be greased up and tighen a bit).

Now I'm having a hell of a time getting a good quality print. Just leveling the bed it's become a nightmare. I'm at my witts end!

Auto leveling and z probing work fine but when I try to print the extruder cartridge bangs against the bed even after the z offset is set to -2.46mm.

I've tried using simplify3d, repetier host, or pronterface and it still has the same issue.

Thanks,

Steve

http://www.soliforum.com/topic/8408/bed … beginners/

Should be all you need.

]]> https://www.soliforum.com/user/7731/ 2018-12-03T01:59:28Z https://www.soliforum.com/post/147734/#p147734 <![CDATA[Bed leveling nightmares!]]> Hey all,  I have a davinci AiO 1.0 with repetier .92.10M it was running fine until my x axis started acting up, I fixed it (it needed to be greased up and tighen a bit).

Now I'm having a hell of a time getting a good quality print. Just leveling the bed it's become a nightmare. I'm at my witts end!

Auto leveling and z probing work fine but when I try to print the extruder cartridge bangs against the bed even after the z offset is set to -2.46mm.

I've tried using simplify3d, repetier host, or pronterface and it still has the same issue.

Thanks,

Steve

]]> https://www.soliforum.com/user/15336/ 2018-12-03T00:12:15Z https://www.soliforum.com/post/147731/#p147731