<![CDATA[SoliForum - 3D Printing Community — Replacement parts - are they all the same?]]> 2017-12-07T17:04:33Z PunBB https://www.soliforum.com/topic/16943/replacement-parts-are-they-all-the-same/ <![CDATA[Re: Replacement parts - are they all the same?]]> Da Vinci 1.0 use 12V 35W, not sure about Da Vinci 1.0 pro. You can find it on the metal heating tube, should labeled with laser engraving. People have been used 12V 40W on Da Vinci 1.0, it was said heating faster than stock heater without issue. Not sure if it holds true on Da Vinci 1.0 pro.

http://www.soliforum.com/topic/6324/xyz … -properly/

]]> https://www.soliforum.com/user/17164/ 2017-12-07T17:04:33Z https://www.soliforum.com/post/140448/#p140448 <![CDATA[Re: Replacement parts - are they all the same?]]> The only thing I can tell you is make sure that the voltage and wattage are the same. The one you linked to is 12V 40W.

]]> https://www.soliforum.com/user/13167/ 2017-12-07T13:22:29Z https://www.soliforum.com/post/140440/#p140440 <![CDATA[Replacement parts - are they all the same?]]> Hello all.

I have a 1.0 Pro and I need replacement parts. First I only needed a thermister, and I read through this forum and others saying all of them were pretty much the same, so that new part is in hand. But when I replaced that, the wires from my heating tube snapped off and obviously I need a new one. I contacted the XYZ service and they are being less than helpful so far.

What I'd like to know is, I found a heating tube on eBay (same place I found the thermister) and I want to know, if anyone can tell me, if it will work with my printer. I'm putting a link here so show the one I found. My apologies to the mods if this isn't allowed.

https://i.ebayimg.com/images/g/n3sAAOSwZB9Z6LV4/s-l1600.jpg

https://www.ebay.com/itm/5PCS-1m-Single … 1438.l2649

I'd REALLY like to get this back up before Christmas, so any help is much appreciated.

Thanks!

]]> https://www.soliforum.com/user/14857/ 2017-12-07T11:30:57Z https://www.soliforum.com/post/140439/#p140439