SoliForum - 3D Printing Community — Repetier question

Re: Repetier question

2013-03-03T15:32:41Z

Schieggster,

I printed one of these guys before. Check out my end results here:
http://www.soliforum.com/topic/987/low- … able-mask/

Re: Repetier question

2013-03-03T08:09:17Z

lotw_1 wrote:

It is close to what it will look like, the light blue lines is the path the extruder will make, you can turn that off with the show travel button at the top and then you can see pretty much what it will look like.

Ahh, alright.

And thanks for the heads up about the travel lines, I would have continued to look over that button if you hadn't told me

Re: Repetier question

2013-03-03T08:04:00Z

It is close to what it will look like, the light blue lines is the path the extruder will make, you can turn that off with the show travel button at the top and then you can see pretty much what it will look like.

Repetier question

2013-03-03T07:16:07Z

I sliced this mask (http://www.thingiverse.com/thing:39851) Using Slic3r .3mm in Repetier, and I'm just wondering if the resulting G-Code image is anything relevant to the print (What it will look like), or it's just what it looks like in the program.