<![CDATA[SoliForum - 3D Printing Community — stand alone slic3r]]>2013-02-26T22:59:25ZPunBBhttps://www.soliforum.com/topic/1477/stand-alone-slic3r/<![CDATA[Re: stand alone slic3r]]>I had a hard time finding this button myself. One would think that it would be on the gcode tab next to the new and save buttons. But the Load GCode button (on RH-Mac) is to the Right of the Connect/Disconnect button at the top left of the interface.]]>https://www.soliforum.com/user/366/2013-02-26T22:59:25Zhttps://www.soliforum.com/post/14224/#p14224<![CDATA[Re: stand alone slic3r]]>Export the g-code from kisslicer to a known location, then start repetier and load your g-code....from menu in RH.]]>https://www.soliforum.com/user/614/2013-02-26T20:37:02Zhttps://www.soliforum.com/post/14210/#p14210<![CDATA[Re: stand alone slic3r]]>thanks I'll try that but still need to know how to get the g-code from there to RH]]>https://www.soliforum.com/user/574/2013-02-26T20:19:29Zhttps://www.soliforum.com/post/14207/#p14207<![CDATA[Re: stand alone slic3r]]>I would try using a different slicer if you are still having problems.
just make sure you set the offset as indicated in the thread so that the prints are centered.
]]>https://www.soliforum.com/user/55/2013-02-26T16:24:55Zhttps://www.soliforum.com/post/14154/#p14154<![CDATA[stand alone slic3r]]>If use the standalone ver of slic3r, how do I the G-code it creates in RH , I know RH has slic3r in it but there was a post about using it alone since I can't get objects to print in center of the bed even tho it shows centered in RH. Make sense?]]>https://www.soliforum.com/user/574/2013-02-26T01:04:59Zhttps://www.soliforum.com/post/14103/#p14103