Are you sure you followed step 4 correctly?
Many users including myself said they had to verify/compile several times to function properly. So backtrack a few steps, be certain you try a few times, and you may have it.
The E3D is worth the stress! 
That means windows can't find hid_bootloader_cli, which is the program you were supposed to navigate to in step 28. Are you sure you unzipped hid_bootloader_cli to the folder shown at the command line?
It has nothing to do with write/verify, the program that does the writing (hid_bootloader_cli) can't be found according to that error.
^ that
]]>It has nothing to do with write/verify, the program that does the writing (hid_bootloader_cli) can't be found according to that error.
]]>Many users including myself said they had to verify/compile several times to function properly. So backtrack a few steps, be certain you try a few times, and you may have it.
The E3D is worth the stress!
So ive went through all the instructions for flashing the firmware but i keep having problems
When I get to this step....
28. Within the CMD window, navigate to the folder you unzipped the BootleaderHID to in step 23
29. Type “hid_bootloader_cli -mmcu=at90usb1286 -w -v Marlin.cpp.hex” (no quotations)
I get this messege...
Is not recognized as a internal or external command, operable program or batch file
The board says..
Solidoodle LLC
Motherboard REV-E
ATMEC 90usb1286
I have a windows 7 computer
Any help is greatly appreciated, I would really like to get printing again.
Thanks!!!!!
]]>