1 Topic by proctor_richard

  • proctor_richard
  • Member
  • Offline
  • Registered: 2013-09-08
  • Posts: 157

Topic: stickky request -repetier host and simplify 3d setup.

Can we get a sticky thread for a simple step by step guide to seeing up repetier host with the press.

Also if anyone has had any look with simplify 3d that would be awesome too

SD2 - mirror bed - e3d v6 - extruder cooling fan - no enclosure.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: stickky request -repetier host and simplify 3d setup.

Start a thread with useful information and we can move appropriate posts into it.
Then we can make that a sticky.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by Dream-Cypher

  • Dream-Cypher
  • Member
  • Offline
  • From: Pennsylvania
  • Registered: 2014-08-26
  • Posts: 157

Re: stickky request -repetier host and simplify 3d setup.

Repetier Host settings were posted here by Soliryan... those work OK to get things going... I'm sure they could use tweaking.

I have some settings that work for S3D.... again, I was able to print with them, but I don't really use S3D, so I'm sure they could use some tweaking....

Machine settings:
http://i.imgur.com/NRL8Zuu.png

Process settings (.fff) attached.

Post's attachments

Solidoodle Press.fff 8.29 kb, 67 downloads since 2015-02-08 

You don't have the permssions to download the attachments of this post.