1 Topic by mersi

  • mersi
  • Newbie
  • Offline
  • Registered: 2014-11-21
  • Posts: 2

Topic: Help please! 2nd layer problem

Hello,

i always have the same Problem with printing the sampel.
The first layers looks fine but the 2nd is totally wrong.

i hope someone  can help me!


thanks
mersi

Post's attachments

f1.jpg
f1.jpg 1.18 mb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by Eder

  • Eder
  • Member
  • Offline
  • Registered: 2014-09-01
  • Posts: 40

Re: Help please! 2nd layer problem

The only time that happened to me was when the printer's head was physically detained either by the cable length.
Does this happen every time?
What firmware are you using?

3 Reply by mersi

  • mersi
  • Newbie
  • Offline
  • Registered: 2014-11-21
  • Posts: 2

Re: Help please! 2nd layer problem

thanks for your fast Response!

i think i found the solution for my Problem.
the Filament cartridge doesnt give enough Filament, so after some layers the printer´s head cannot move.

thank you for your help!