1 Topic by cephdon

  • cephdon
  • Member
  • Offline
  • Registered: 2012-11-13
  • Posts: 79

Topic: MFG / Part Number for extruder and thermocouple connectors?

Does anyone happen to know the manufacturer and part number for the connectors that hook up the hot end heater and thermocouple?  I would like to wire up a few extra hot ends, but want the correct connectors for it.

I might change them all out eventually, but I thought I would start here first.

2 Reply by devilman2075

  • devilman2075
  • Member
  • Offline
  • Registered: 2012-08-21
  • Posts: 154

Re: MFG / Part Number for extruder and thermocouple connectors?

I think you'd be better off upgrading rather than running the same setup. There's been a few issues with people and those connectors going bad. You'd be better off getting something that'll hold up to the elements

3 Reply by cephdon

  • cephdon
  • Member
  • Offline
  • Registered: 2012-11-13
  • Posts: 79

Re: MFG / Part Number for extruder and thermocouple connectors?

Ok. Didn't know that. Upgrade it is.