1 Topic by Serin

  • Serin
  • Serin
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 382

Topic: When in doubt.. BURN EVERYTHING

Well.... This is amusing.
Though I'm not sure I learnt anything.

https://www.shapeways.com/blog/archives … -fire.html

This is a crowd funding thing that I'm running: http://www.gofundme.com/bvi140 It's for pretty selfish reasons tongue

2 Reply by Claghorn

  • Claghorn
  • Member
  • Offline
  • From: Delray Beach, FL
  • Registered: 2012-10-22
  • Posts: 730

Re: When in doubt.. BURN EVERYTHING

No doubt someone has videos of 3D prints running through a blender as well :-).

Claghorn's Website

3 Reply by grob

  • grob
  • grob
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2014-01-02
  • Posts: 900

Re: When in doubt.. BURN EVERYTHING

I tried searching "will it blend 3d print" and came up short.
I feel kind of disappointed. tongue

SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi

4 Reply by Claghorn

  • Claghorn
  • Member
  • Offline
  • From: Delray Beach, FL
  • Registered: 2012-10-22
  • Posts: 730

Re: When in doubt.. BURN EVERYTHING

grob wrote:

I tried searching "will it blend 3d print" and came up short.
I feel kind of disappointed. tongue

Especially since that might actually be a good way to recycle prints by running them through a filastruder after blending :-).

Claghorn's Website