1 Topic by Retroplayer (edited by Retroplayer 2014-08-08 17:08:45)

  • Retroplayer
  • Member
  • Offline
  • Registered: 2014-07-05
  • Posts: 128

Topic: SD4 modified Z Endstop

I thought I would share these with the community here. When I decided I wanted to experiment with various bed surfaces, it was necessary to change the adjustment range of the Z Endstop. All modified adjustment tabs I found were for SD2 and SD3. As you might be aware, the SD4 has a slightly different Z Endstop adjustment set-up. So I had to design my own. I designed a small variety (low, lower, and higher.)

These are designed to use 2mmx8mm full thread inserts (http://www.ebay.com/itm/190904532862?ss … 1497.l2649). Just press them in, thread in your adjustment screw and mount in place of the original.

I am attaching the STL and the Sketchup 2013 file so that you can modify it however you like.

Post's attachments

Z-Stop-low.stl 95.57 kb, 38 downloads since 2014-08-08 

Z-Stop-lowest.stl 97.09 kb, 19 downloads since 2014-08-08 

Z-Stops-higher.stl 94.38 kb, 16 downloads since 2014-08-08 

Z-Stops.skp 67.7 kb, 2 downloads since 2014-08-08 

You don't have the permssions to download the attachments of this post.