1 Topic by Ggalisky (edited by Ggalisky 2014-08-15 00:09:02)

  • Ggalisky
  • Ggalisky
  • Member
  • Offline
  • From: California
  • Registered: 2014-05-21
  • Posts: 487

Topic: GP-35 Review

I recently bought 10 pounds of GP-35 pellets from http://3dsupplysource.com/, and loaded them into my Filastruder. They extrude just a tad slower than MG94, but still work great. Tolerances of + or - 0.05mm are still present. It is cheaper than MG94 which is good.

Pros
Cheaper than MG94
Tolerances of + or - 0.05mm

Cons
extrudes a bit slower than MG94 (still testing this, so this maybe inaccurate)

Here is a video of me printing with it. My printers not calibrated too well, and I apologize for the bad video quality in advance.
http://www.youtube.com/watch?v=qr-JH-17F5g

Ulitmaker 2, a few repraps, Custom Big FFF 3D printer with heated chamber.

My Blog http://ggalisky.weebly.com/
My Youtube https://www.youtube.com/channel/UCXShYo … aDUpebDAOw

2 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: GP-35 Review

Looks good! Can you quantify "a tad slower"?

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend

3 Reply by Ggalisky

  • Ggalisky
  • Ggalisky
  • Member
  • Offline
  • From: California
  • Registered: 2014-05-21
  • Posts: 487

Re: GP-35 Review

At this point I do not have any numbers, but when I was extruding MG94 during the purge the filament was extruding faster. At least that is what I think. I plan to get some MG94 and compare the two at some point in the next 2 weeks. I will post an update when that happens.

Ulitmaker 2, a few repraps, Custom Big FFF 3D printer with heated chamber.

My Blog http://ggalisky.weebly.com/
My Youtube https://www.youtube.com/channel/UCXShYo … aDUpebDAOw