1 Topic by elefort (edited by elefort 2014-07-12 21:56:24)

  • elefort
  • Member
  • Offline
  • Registered: 2014-02-16
  • Posts: 30

Topic: Firmware update comm ports not showing

Hello everyone,

I'm having the following issue:

After performing all the compiling and moving over the hex file to the Lincomatic HID bootloader. I hooked up my printrboard rev e and I was able to see the com ports on my device manager however when I apply the jumper and press the reset button I can no longer view any com ports. It completely disappears. Has anyone had this issue?

I included screenshots of my issue: DM1 when I initially hooked up my printrboard rev e. DM2 is after I applied the jumpers and pressed the reset button.

Thx in advance for your help!

Post's attachments

DM1.jpg
DM1.jpg 51.02 kb, file has never been downloaded. 

DM2.jpg
DM2.jpg 50.07 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.